2. The REN is useful to determine the quantity of devices you may
connect to your telephone line and still have those devices ring when
your number is called. In most, but not all areas, the sum of the
RENs of all devices should not exceed five (5). To be certain of the
number of devices you may connect to your line, as determined by the
REN, you should call your local telephone company to determine the
maximum REN for your calling area.
3. If the device causes harm to the telephone network, the telephone
company may discontinue your service temporarily. If possible, they
will notify you in advance; if advance notice is not practical, you will
be notified as soon as possible. You will be advised of your right to
file a complaint with the FCC.
4. Your telephone company may make changes in its facilities,
equipment, operations, or procedures that could affect the proper
operation of your equipment. If they do, you will be given advance
notice to give you an opportunity to maintain uninterrupted service.
5. If you experience trouble with this product, contact your authorized
reseller, or call IBM. In the United States, call IBM at
1-800-772-2227. In Canada, call IBM at 1-800-565-3344. You may
be required to present proof of purchase.
The telephone company may ask you to disconnect the device from
the network until the problem has been corrected, or until you are sure
the device is not malfunctioning.
6. No customer repairs are possible to the device. If you experience
trouble with the device, contact your Authorized Reseller or see the
Diagnostics section of this manual for information.
7. This device may not be used on coin service provided by the
telephone company. Connection to party lines is subject to state
tariffs. Contact your state public utility commission or corporation
commission for information.
8. When ordering network interface (NI) service from the local Exchange
Carrier, specify service arrangement USOC RJ11C.
Canadian Department of Communications certification label
NOTICE: The Canadian Department of Communications label identifies
certified equipment. This certification means that the equipment meets
certain telecommunications network protective, operational, and safety
Appendix C. Product warranties and notices 147
To Next Page
Loading...
