System management features
Remote Program Load (RPL) and Dynamic Host Configuration Protocol
(DHCP)
Wake on LAN (requires Wake on LAN-supported network adapter)
Wake on Ring (in the Configuration/Setup Utility program, this feature
is called Serial Port Ring Detect for an external modem and Modem
Ring Detect for an internal modem)
Wake on Alarm
Ability to update POST and BIOS over the network (in the
Configuration/Setup Utility program, this feature is called Remote
Administration)
Automatic power-on startup
System Management (SM) BIOS and SM software
Ability to store POST hardware test results
Input/output features
25-pin, ECP/EPP parallel port
Two 9-pin, 16550 UART serial ports
Two 4-pin, USB ports
Mouse port
Keyboard port
15-pin monitor port
Three audio connectors (line/headphone out, line in, and microphone)
Expansion
Four drive bays
Four PCI expansion slots with support for Plug and Play adapters
PCI slot 2 supports the Alert on LAN feature for use with Alert on
LAN-supported network adapters
Power
Manual switch between ranges, 90–137/180–265 V ac
Automatic switching, 57–63/47–53 Hz input frequency range
Built-in overload and surge protection
Advanced Power Management support
Advance Configuration and Power Interface (ACPI) support
Chapter 1. IBM PC 300GL overview 5
To Next Page
Loading...
Need help?
General