IBM PC 300GL

Table 3 (Page 2 of 5). Network-related settings
To configure: Select: Comments:
Wake on LAN 1. Power Management
2. Automatic Power On
3. PCI Wake Up and
press Enter.
4. Enabled or Disabled.
If you select Enabled,
continue to the next
step.
5. Startup Sequence
6. Primary or Automatic.
Go back to the main
menu.
7. Start Options
8. Startup Sequence
9. The first, second, third,
and fourth primary
startup devices
10. Automatic Power On
Startup Sequence
11. The first, second, third,
and fourth startup
devices
You might not be able to
select four startup devices
for your model.
Wake on PCI 1. Power Management
2. Automatic Power On
3. PCI Wake Up and
press Enter.
4. Enabled or Disabled.
If you select Enabled,
continue to the next
step.
5. Startup Sequence
6. Primary or Automatic.
Go back to the main
menu.
7. Start Options
8. Startup Sequence
9. The first, second, third,
and fourth primary
startup devices
10. Automatic Power On
Startup Sequence
11. The first, second, third,
and fourth startup
devices
You might not be able to
select four startup devices
for your model.
Chapter 4. Configuration/Setup Utility program 45