To install a U-bolt:
1. Use a tool, such as a screwdriver, to remove the two metal knockouts.
2. Insert the U-bolt through the rear panel; then attach and tighten the
nuts with an appropriately sized or adjustable wrench.
3. Replace the computer cover. For more information, see “Replacing the
cover and connecting the cables” on page 82.
4. Thread the cable through the U-bolt and around an object that is not a
part of or permanently secured to the building structure or foundation,
and from which it cannot be removed; then fasten the cable ends
together with a lock.
Completing the installation
After working with options, you need to install any removed parts, replace
the cover, and reconnect any cables, including power cords and telephone
lines. Also, depending on the option installed, you might need to update
information in the Configuration/Setup Utility program.
The following list is a quick reference to these procedures:
“Replacing the cover and connecting the cables” on page 82
“Updating the computer configuration” on page 84
Chapter 6. Installing options 81
To Next Page
Loading...
