RIPL (Remote Initial Program Load): Enables you to select a
remote system from which to load programs via a network
adapter when your system unit is first turned on. This option
also allows you to configure network adapters which require
setup.
SCSI ID: Allows you to view and change the addresses (IDs) of
the SCSI controllers attached to your system unit.
Update: Allows you to update the system firmware program.
Console: If you have more than one keyboard and display
attached to your system unit, or if you have an ASCII terminal
attached to your system unit in addition to a keyboard and
display, this tool allows you to define which one is active.
Chapter 6. System Management Services 6-9
To Next Page
Loading...
