OK Prompt: Provides access to the Open Firmware command prompt.
Multiboot Start Option: Toggles between OFF and ON and selects if the Multiboot
menu invokes automatically on startup or not.
Select Boot Devices
This selection enables you to view and change the custom boot list, which is the
sequence of devices read at startup time.
à ð
Select Boot Devices
1. Display Current Settings
2. Restore Default Settings
3. Configure 1st Boot Device
4. Configure 2nd Boot Device
5. Configure 3rd Boot Device
6. Configure 4th Boot Device
7. Configure 5th Boot Device
.------.
|X=Exit|
------'
====>
á
ñ
Display Current Settings: Lists the current order of devices in the boot list. The
following screen shows an example of this display.
à ð
Current Boot Sequence
1. Diskette
2. Ethernet (Integrated)
3. SCSI CD-ROM id=3 (slot=1)
4. SCSI 5MB Hard Disk id=6 (slot=1)
5. SCSI 5MB Hard Disk id=5 (slot=5)
.------.
|X=Exit|
------'
===>
á
ñ
Chapter 6. System Management Services 6-27
To Next Page
Loading...
