IBM Series 1 - Page 11

~!lgJ2!:~~ .Q.!. ~"y§!Q'!~.I Qi~§st. prQgJ;~,! ~.Q!!trol Aggj2:.t~!: 19at.YJ;~.
The introduction to this chapter describes the customer
direct proqram centrol adapter feature. A block diagram
shows the data flov from the processor I/O channel through
the direct proqram control adapter to the user's devices.
The remaining sections of this chapter provide:
• Detailed information about the signal lines.
• Operational characteristics--this section consists of
tiainq charts and descriptive text for the various
siqnal sequences. Special timing requirements are shown
on the charts. Timing charts arE included for: an
output sequence, an Lnpu t sequence, and an interrupt
service sequence.
• Electrical characteristics--this provides driver and
receiver specifications for attaching the user's
device(s).
• Physical characteristics--this section provides
connector information and signal pin assignments at (1)
the connectors for the adapter feature and (2) the
connectors for the customer access panel feature.
PREREQUISITE PUBLICATIONS
•
IBK Ser ies/l
Model
3:
4953 Processor and Processor
Features Description,
GA34-0021
. .
•
or
•
IBM Series/l
Model
5:
4955
Processor and Processor
Features Description,
GA34-0022
•
IBM
Series/1:
Customer Direct Program
Control
Adapter
Feature Description, GA34-0031
BELATED PUBLICATIONS
• IBM Series/l Physical Planning Manual, GA34-0029
• IBM Series/1 Coniiqurator, GA34-0042
!21~. Installation instructions are shipped with each system
order. These instructions contain the information required
for selectinq options and device addresses on the I/O
attachment feature cards.
x GA34-0033
( ~
" .t
#
,