IBM Series 1 - Page 9

SUMMARY OF PUBLICATION
~ha.Ql~[ 1.!. In.t.f.2!i'y
ct
iQ'!!- This chapter introduces the reader
to the I/O channel and the user attachment features that are
described in the subsequent chapters. A block diagram shovs
where the user attachment features are located with respect
to the processor and the I/O channel. The attachment points
covered are:
• Processor I/O channel
Channel socket adapter fEature
Channel repower feature
• Timer feature
• Teletypewriter adapter feature
• Inteqrated diqital input/output non-isolated feature
• customer direct proqram control adapter feature
~hg.Qt~~ ~~ E£Q£~§§Q~ lLQ ~h~nngl. The introduction to this
cha pter provides a qenera 1 description of the channel,
direct proqram centrol (DPC) operations, cycle steal (CS)
operations. interrupts, and initial program load (IPL).
•
•
•
•
The remaininq sections of this chapter provide:
Siqnal line descriptions--this section includes a list
of the I/O channel siqnal lines and identifies groups
and subsets of the lines. A functional description is
included for each siqnal line.
Operational characteristics--this section consists of
timinq charts and descripti v€ text for the various
siqnal sequences that can occur on the I/O channel.
Special timinq requirements and maximum skew are shown
on the charts.
Electrical characteristics--this includes (1) electrical
requirements for dr1vers and receivers and a) other
attachment considerations.
Phvsical characteristics--this section provides
connector information includinq illustrations and signal
pin assiqnments. This information is supplied for the:
1. I/O channel cahle connectors,
2. Channel socket adapter feature, and
3. C han DEI repo werfea ture.
~h~Qi§r 1~ Ii~§~ 1~~!Y£§. The introduction to this
provides a qeneral descripticn of the timer
includinq a block diaqram.
chapter
feature
•
•
•
•
The remaininq sections of this chapter provide:
Detailed information about the timer signal lines.
Operational characteristics of timer interrupts.
Timer electrical characteristics--tbis includes driver
and receiver information for external control of the
timers.
Timer physical characteristics--this section provides
connector information, including an illustration and
siqnal pin assiqnments for the connector located on the
printed circuit card.
viii GA34- 0033
( ;