Functions of Your Computer
ThinkPad Utility Programs
Your computer has the following utility programs for easy
configuration:
Easy-Setup
ThinkPad Configuration program
This section summarizes these utility programs.
Easy-Setup
Your computer provides a user-friendly program called
Easy-Setup
,
which allows you to select various setup parameters:
Config: Set the configuration of your computer.
Date/Time: Set the date and time.
Password: Set a password.
Start up: Set the startup device.
Test: Test the system.
Restart: Restart the system.
To start Easy-Setup, do as follows:
1
Power off the computer, and remove any diskette from
the diskette drive.
2
Press and hold F1; then power on the computer. Hold
F1 until the “Easy-Setup” menu appears.
> If you have set a password, the “Easy-Setup” menu appears
> after you enter the password.
Date/Time
Password
Easy-Setup
Start up
Test
Restart
Config
BIOS part number, Date
System-unit serial number
System board serial number
Microprocessor
nnnnnnnnnnnnnn
nnnnnnnnnnn
Pentium( ) II Processor
**
nnnnnnn
12/31/98
UUID
nnnnnnnn-nnnn-nnnn-nnnn-nnnnnnnnnnnn
Trademark of Intel Corporation
**
16 IBM ThinkPad 600E User's Reference
To Next Page
Loading...
