Functions of Your Computer
* The HDD-1 to HDD-4 icons are assigned to each hard disk drive
* in the following priority:
* 1. The primary hard disk drive (placed in the hard disk bay of
* the computer)
* 2. A hard disk drive in the UltraslimBay
* 3. A hard disk drive in the UltraslimBay tray of the docking
* station
* 4. A hard disk drive in the device space of the docking station
* 5. A hard disk drive connected to the computer with a SCSI
* connector
* For example, if you don't have the hard disk drive in the
* computer's UltraslimBay but you have one in the docking station,
* that hard disk drive becomes HDD-2.
* If you are using a
remote program loading (RPL) system
* through a token-ring card or some other network card, do the
* following:
* 1. Select Network and click on it. The “Speed” menu appears.
* 2. If you are using a token-ring card, select the speed you want
* (4 or 16), and click on it; then press Enter.
* If you are using a network card other than a token-ring card,
* such as an Ethernet card, you need not specify the RPL
* speed. Press Esc to exit this menu.
* If you select PCMCIA, representing, for example, ATA-3 HDD or
* a Flash memory card, and cannot start the system, disable the
* secondary IDE device and restart the system. Some cards might
* not be compatible with a CD-ROM or DVD-ROM drive.
* The CDROM icon is assigned to the CD-ROM drive in the
* UltraslimBay. If you don't have a CD-ROM drive in the
* UltraslimBay but you have one in the docking station, that
* CD-ROM drive becomes CDROM. If you have CD-ROM drives
* in both the UltraslimBay and the docking station, the CD-ROM
* drive in the UltraslimBay becomes CDROM.
Chapter 1. Getting Familiar with Your Computer 23
To Next Page
Loading...
