Installing Software for Windows 98
This section describes the installation procedures for Windows 98
and its software for your computer.
Note: You can install Windows 98 by restoring the original preloaded
image from the Recovery CD. Refer to the
User's Reference
for how to use the Recovery CD.
Overall Procedure
1
Have the Windows 98 installation package in hand.
2
Back up your software and personal data files on the hard disk.
3
Create the Windows 98 Supplement File Diskette using the
Diskette Factory preloaded on the hard disk.
4
Create the diskettes of the device drivers using the Diskette
Factory. You need to create at least the following device driver
diskettes:
5
Install Windows 98 and the software.
Device Driver Diskette Name
ThinkPad Configuration
program
Utility Diskette for Windows 98
Utility Data Diskette I for Windows 98
Utility Diskette for DOS, Personalization
Display driver Video Features Diskette (NM2200) for
Windows 95/98
Audio device driver Audio Features Diskette for Windows 95/98
TrackPoint driver TrackPoint Driver Diskette for Windows
95/98/NT
ThinkPad modem driver ThinkPad Modem for Windows 95/98/NT
Installing Microsoft Windows 98
If you are installing Windows 98 on a drive other than the C drive,
more than 25 MB is required on the C drive.
1
Install the Windows 98 CD-ROM into the CD-ROM drive.
108 IBM ThinkPad 600E Online Book
To Next Page
Loading...
