IBM ThinkPad 600e - Page 144

| 7 Click on Change.
| 8 Click on Have Disk....
| 9 Make sure that the source drive is A:\ and click on OK.
| 10 Click on PS/2 TrackPoint in the list.
| 11 Click on OK.
| 12 Click on Close in the “Mouse Properties” window.
| 13 Remove the TrackPoint Driver Diskette for Windows 95/98/NT
| from the diskette drive, and restart your computer to make the
| new settings effective.
Installing the Infrared Device Driver for Windows NT
You can use infrared features using Windows NT dial-up networking.
The Windows NT infrared device driver provides you IrDA 1.0
compliant functions, enabling infrared communication up to 115
Kbps.
To install the infrared device driver for Windows NT:
1 Start Windows NT, and log on with the user ID authorized as
an administrator.
2 Click on Start and Run...
3 Insert the Infrared Driver for Windows NT 4.0 into the diskette
drive.
4 Type A:\INSTALL and press Enter.
Follow the instructions on the screen.
5 Restart the computer.
After the installation, COM 1, IRQ 4, and I/O address X'3F8' are
assigned for the infrared port.
To enable the infrared port as COM 1, use the ThinkPad
Configuration program.
136 IBM ThinkPad 600E Online Book