IBM ThinkPad 600e - Page 152

Then use the newest program among the ones for the DOS,
Windows, and CDROM directories for each drivers.
You can easily use the newer one by changing the subdirectory
name in the CONFIG.SYS or AUTOEXEC.BAT. For example,
if the ones in DOS were the newest, you would change:
C:\WINDOWS\SMARTDRV.EXE
to:
C:\DOS\SMARTDRV.EXE
If you start Windows from the DOS prompt, do not close the LCD
while the program is loading; if you do, the computer will stop
running.
Installing the ThinkPad Configuration Program for Windows
3.1
If you are going to use Windows, install the ThinkPad Configuration
program for DOS first. Installing the ThinkPad Configuration
Program for DOS.
Then do the following to install the ThinkPad Configuration program
for Windows 3.1:
1 Start Windows.
2 Click on File from the “Program Manager” window; then click
on Run... from the pull-down menu.
3 Insert the Utility Diskette for Windows 3.1 into the diskette
drive; then type A:\INSTALLW and press Enter.
4 Follow the instructions on the screen.
Default choices are already selected in the “Installation
Options” window.
Installing the Display Driver for Windows 3.1
Do the following to install the display driver for Windows 3.1 so that
you can get a correct display setting and better performance:
1 Start DOS; then go to the WINDOWS subdirectory.
144 IBM ThinkPad 600E Online Book