Note:
You must set the Resume on incoming call option in the ThinkPad
Configuration program so the computer automatically resumes normal
operation.
For Windows 95 and Windows 98:
1.
Click on the Power Management ( ) button.
2.
Click on the Suspend/Resume options tab.
3.
Select the Resume on incoming call option.
For Windows NT, Windows 3.1, or OS/2:
1.
Click on the Battery ( ) button.
2.
Click on the Suspend/Hibernation/Resume options ( ) button;
then select the Resume on incoming call option.
For DOS:
Enter PS2 RI E
Considerations for Hibernation Mode
Consider the following before using hibernation mode:
Do not run any other tasks while the hibernation file is being
created.
The computer uses battery power to enter hibernation mode.
Therefore, it reserves some battery power if it is set to enter
hibernation mode when a low-battery condition occurs. This can
cause the battery operating time to be shorter than the time
publicly stated.
Do not add or remove memory during hibernation mode. If you
do, the computer resumes from hibernation mode without
recognizing the changed memory size. To ensure that the
computer recognizes the correct memory size, shut down; then
restart your operating system.
If the computer is powered with battery power, it turns power off
to the PC Card when entering hibernation mode. When normal
operation resumes, if the PC Card or computer does not operate,
restart the application or computer.
If you are using some communication cards and your computer
is powered with ac power, the computer does not enter
hibernation mode. This prevents possible problems from
Chapter 4. Using Your Computer with a Battery Pack 41
To Next Page
Loading...
