3
Follow the instructions on the screen.
Formatting an SRAM Card
Before using an SRAM card, you have to format it using the DOS
FORMAT command. Do the following:
1
Type the following:
FORMAT drive_letter:
(drive_letter is the actual drive letter.)
2
Press Enter.
For more instructions on using FORMAT, see your DOS user's
guide.
Memory Card Partitions and Drive Letters
MTDDRV assigns drive letters to each partition on a memory card to
allow each partition to be accessed as if it were another hard disk
drive.
You can display the drive letters it reserves at system boot or by
entering the following at the DOS prompt from within the directory
containing the CardWizard files:
MTDDRV /?
If the first available letter is F, MTDDRV reserves drive letter F for
your first PC Card slot and letter G for your second PC Card slot.
These drive letters are reserved whether you are actually using them
for memory card partitions or not.
Note: The situation described in this example could create a
problem if you are connected to a network, especially if you
are mapped to numerous network drives. The system might
run out of drive letters to assign before all your network drives
have been properly mapped. The drive letters that MTDDRV
reserves might cause all other drive letters to be reassigned
(excluding drive letters for local hard disks or ATA cards).
For example, if you have a network drive that is normally drive
F and you install MTDDRV, the network drive will no longer be
assigned drive letter F on your system. As a result, you might
Chapter 5. Using Your Computer with a PC Card 67
To Next Page
Loading...
