EasyManua.ls Logo

IBM x3250 M3 - Page 15

IBM x3250 M3
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IBM Asia Pacific Hardware Announcement AG10-0236 IBM is a registered trademark of International Business Machines Corporation
15
The System x3250 M3 server includes a standard 351 W power supply. This power
supply provides sufficient power to run the server fully configured with supported
devices.
Cable orders
The dual 10/100/1000 Mbps, full-duplex Ethernet controllers, standard with the
System x3250 M3 server, are connected directly to independent RJ-45 connectors.
The RJ-45 connectors provide a 10BaseT, 100Base-TX, or 1000Base-TX interface
for connecting a twisted-pair cable to the Ethernet network. Cabling is not included
with the server. To connect the Ethernet controller to a repeater or switch, use a UTP
cable with RJ-45 connectors at both ends. For 100 Mbps or more operation, category
5 or better cabling must be used.
There are no additional cabling requirements, other than for system power,
keyboard, mouse, and monitor connections.
Installability
The System x3250 M3 server requires about 20 minutes for installation. Installation
includes unpacking, setting up, and powering on the system. Additional time is
required to install an operating system, additional adapters, or features.
Packaging
The system unit carton contains:
System unit
Rack kit
One system unit power cord
Country kit:
System x3250 M3 Installation Guide
Safety flyer
Rack install instructions
Documentation (CD)
Diagnostics (CD)
ServerGuide (CD)
IBM Director (CD)
Contents flyer
System x3250 M3 models are shipped as a single package. The country kit carton is
contained inside the top portion of the system unit carton.
Supplies
None
Security, auditability, and control
Security and auditability features:
Power-on and privileged access password functions control who has access to the
data and server setup program.
Selectable boot sequence can prevent unauthorized installation of software or
removal of data from the diskette drive.
These servers are intended to be installed and secured in a rack. It is the customer's
responsibility to ensure that the server and rack installation are secure to prevent
sensitive data from being removed.

Related product manuals