iCandy
iCandy
Depress bottom section of the
large grey outer ring on each side
of the adaptor bracket and lift off.
Orientate the car seat bracket
with the curved bar to the front
of the chassis. Insert adaptor
bracket into the upper receptors
of the Blossom converter bars
and press down rmly to engage.
forward
facing only Position the car
seat over the adaptor brackets
so that the 2 vertical latch points
are in line with the 2 rectangular
apertures in the car seat base
and the rear bar of the adaptor is
in line with the light grey hooks at
the rear of the car seat.
Press down rmly to ensure
both vertical latches and rear
hook latch are fully engaged.
Once tted, lift the car seat
upwards to ensure it is correctly
tted.
Always ensure
your car seat and adaptors are
securely tted before use.
7
8
9
10
Peach Inst AUS Print V4.indd 30 21/07/2011 20:24
To Next Page
Loading...
