9
ENGLISH
4. ELECTRICAL CONNECTION
IT IS MANDATORY TO GROUND THE EQUIPMENT.
To avoid possible discharges on individuals or damages to the equipment, the
machine should be grounded pursuant local and/or national regulations as the
case may be.
THE MANUFACTURER SHALL BE HELD HARMLESS IN CASE OF DAMAGES
ARISING DUE TO THE LACK OF THE GROUND INSTALLATION.
The machine is supplied with a 1.5 m (4.92 feet) cable of length. In case the supply cable is damaged, it should
be replaced by a cable of special assembly to be furnished by the manufacturer or post-sale service. Such
replacement should be performed by qualied technical service only.
The machine should be places in such a way as to allow a minimum space between the back and the wall to
allow an easy access and without risks to the cable jack.
Safeguard the base of the jack.
It is convenient to install adequate switches and fuses.
The line up to the jack should have a minimum section of 2.5 mm2 (0.0038 in2)
Voltage and tension are indicated in the nameplate and on the technical specications
of this manual. Variation on voltage above the 10% stated on the nameplate could
result on damages or prevent the machine start-up.
5. INSTALLATION OF MODULAR EQUIPMENTS OVER DEPOSITS OR SILOS
Modular makers should be installed over deposits
or silos, following the instructions contained in this
manual.
The resistance and stability of the
container-machine/s assembly should be veried,
as well as the fastening elements.
6. ASSEMBLY OF THE DISPERSION CONE
(MODULAR MODELS)
This device distributes the ice in the silos, and
avoids ice compression under the exit pipe.
Changing its position, the ice could be directed to
any direction.
To Next Page
Loading...