Ickle Bubba Discovery - Unfolding the Stroller

Using the Front Wheels
1. To assemble, ensure
that the wheel lock
mechanism is located
at the top of the wheel,
then insert each wheel,
lock lever first, into the
front of the pram until
you hear a ‘click’
2. To lock the front
wheels into a fixed
position, raise each
of the lock levers
found on the front
of the wheels.
3. To unlock the
wheels and allow
for better manoeu-
vrability, lower each
of the lock levers
WARNING: THE WHEELS MUST ALWAYS BE BOTH FIXED OR BOTH
SWIVEL FOR CORRECT USE OF THIS STROLLER
Using the Safety Harness
1. Connect each
side strap to the
crotch strap
located in the
centre of the seat
2. To disconnect
the harness, press
the button in the
centre of the crotch
strap
3. To unfasten the
shoulder straps,
release the spring
clips connected to
the side straps
WARNING: ALWAYS USE STROLLER WITH THE CHILD STRAPPED WITH THE SAFETY
HARNESS! USE THE SAFETY HARNESS TOGETHER WITH THE CROTCH STRAP
06 07
Using the Brakes
1. To engage the brake, press down on
either of the clips located over the back
wheels. Push past the second click to fully
engage the locking system and test to
ensure the brakes are fully engaged
2. To release the brake, lift either of
the clips upwards
1. With the footbreak engaged,
attach the bumper bar to the
corresponding slots in the front
of
the stroller
2. Remove the bumper bar by
pressing the button lock under-
neath and pulling it outwards
WARNING: THE BRAKES MUST BE ENGAGED EACH TIME YOUR STOP
WITH YOUR CHILD IN THE STROLLER
Inserting and Removing the Bumper Bar
NOTE: The Discovery bumper bar has 4 sections to allow it to bend, and
for gate opening function
v.02.20
v.02.20