Icom IC-207H - Page 49

| Skip channel setting = =ser wove
1e memory skip function speeds up scanning by checking
ly desired memory channels. Set the memory channels to
) skipped or scanned as follows.
The display shows that
memory channel 10 is set as
a skip channel.
Boch, [BAND] to select the a band, if necessary.
‘Select the memory channel to program or to cancel the
skip function on:
> Select memory mode by pushing [M/CALL] once or twice.
=> Rotate the tuning dial to select the memory channel.
Push [SET] one or more times until “CHS” appears as
shown above.
¢ Pushing [MONI] reverses the order of selection.
Rotate the tuning dial to turn the skip function ON or OFF
‘on the selected channel.
e “(skip)” appears : The memory channel is skipped during
(CHS-on) memory scan.
'° “@xr)” disappears : The memory channel is scanned during
| (CHS-OFF) memory scan.
Push [V/MHz] to exit set mode.
_NOTE: Scan edge memory channels cannot be specified
as skip channels, however, they are skipped during mem-
| ory scan anyway.
An}
SET
B
&
SCAN OPERATION 9
41] Push [BAND] to select the desired band, if nec-
essary.
Select the memory channel to program or to
cancel the skip function on:
> Select memory mode by pushing [MR].
> Push [A] or [¥V] to select a memory channel.
Push [@SET] one or more times until “CHS” ap-
pears as shown at left.
e Pushing [OENT] reverses the order of selection
once entering set mode.
Push [A] or [¥] to set or cancel the skip infor-
mation.
¢ See item @ at left for skip indicator details.
Push [@®CLR] to exit set mode.
ENGLISH