Icom IC-207H - Page 50

Q SCAN OPERATION
@
Scan
resume
vane
SET
MODE
condition
The scan resume condition can be selected as timer, pause
or empty pause scan. The empty pause scan is useful for
finding unused frequencies. The selected resume condition
is also used for priority watch. (p. 44)
The display shows that the
scan resumes 15 sec. after it
stops.
@® Push [BAND] to select a band, if necessary.
@ Push [SET] one or more times until “SCt” or “SCP” appears
as shown above.
¢ Pushing [MONI] reverses the order of selection.
¢ Cancel the DTMF memory encoder in advance. (p. 48)
@® Rotate the tuning dial to set the desired timer.
e“SCt-15” =: Scan pauses 15 sec. while receiving a signal.
e“SCt-10” : Scan pauses 10 sec. while receiving a signal.
e “SCt-5” : Scan pauses 5 sec. while receiving a signal.
e“SCP-2” :Scan pauses until the signal disappears and then
resumes 2 sec. thereafter.
e“SCt-EP” : Scan pauses on a frequency that is not busy and
resumes 2 sec. after a signal appears.
@® Push [V/MHz] to exit set mode.
" m 4
|
[1 Push [BAND] to select the desired band, if ne
essary.
(2] Push [©SET] one or more times until “SCt”
“SCP” appears as shown at left. |
e¢ Pushing [OENT] reverses the order of selecti;
once entering set mode.
Cancel the DTMF memory encoder in advance
(p. 48)
[3] Push [A] or [V] to select the scan resume co
dition.
e See item @ above for scan resume condition detai
Push [®CLR] to exit set mode. .