Icom IC-207H - Page 54

47
11 DTMF MEMORY ENCODER
@ Programming a DTMF code via the microphone
(aay DTMF codes can be directly programmed via the Push [A] or [¥Y] to select the desired channel.
DTMF keypad on the microphone. The contents can be [4] Push the desired digit keys.
NT] overwritten, but cannot be cleared via the micro- ¢ When the first digit is input, previous memory contents
phone. See the previous page for clearing the cleared automatically.
contents. ¢ “E” stands for “*” and “F” stands for “#.”
e Push [A] then [¥], and repeat this step when making a mist
11] Push [FUNC] then [ODTMF] to turn the DTMF ¢ The S/RF indicator shows the digit group. The indication
memory function ON. creases every 6 digits.
¢ ‘d” appears in place of the 100 MHz digit. [5] Push [BAND] to exit the programming condition.
Push
[@SET]
to
enter
the
programming
condi-
*
The
[@CLR]
key
cannot
be
used
to
exit.
If
pushed,
“A”
is
in
tion. and the previously programmed data is erased. Reprog
again in such a case.
[EXAMPLE]: Programming “5428AB453” into DTMF memory channel “d4.”
DTMF
Push then
ee
ci