Icom IC-207H - Page 59

Ft Rh OTE COO
a Tone scan
y monitoring a signal that is being transmitted on a repeater
tout frequency, you can determine the tone frequency nec-
psary to open a repeater.
) Push [BAND] to select a band, if necessary.
) Set the desired frequency to be checked for a tone fre-
quency e.g. repeater input frequency.
) Push for 1 sec. to start the tone scan.
¢ To change the scanning direction, rotate the tuning dial.
) When the tone frequency is matched, the squelch opens
» and the tone frequency is programmed into the selected
mode such as VFO, memory/call channel or scratch pad
| memory.
, ¢ The tone scan pauses when a tone frequency is detected.
e The decoded tone frequency is used for the tone encoder or tone
' encoder/decoder depending on the tone squelch ON/OFF set-
ting.
) Push [V/MHz] to stop the scan.
POCKET BEEP AND TONE SQUELCH 12
rom Push [BAND] to select the desired band, if nec-
i) essary.
[2] Set the desired frequency to be checked for a
tone frequency e.g. repeater input frequency.
Push [F-2] to start the tone scan.
When the tone frequency is matched, the
squelch opens and the tone frequency is pro-
grammed into the selected mode such as VFO,
memory/call channel or scratch pad memory.
[5] Push [®CLR] to stop the scan.
NOTE: The decoded tone frequency is programmed tem-
porarily when a memory or call channel is selected.
However, this will be cleared when overwriting the mem-
ory/call channel.
MQ QS
ENGLISH