Icom IC-207H - Page 60

mg 13
M Connection
Wireless remote control is available when the following op-
tions are used:
¢ HM-90 wiRELESS MICROPHONE
e EX-1759 INFRARED RECEIVER
The BC-96 MICROPHONE HOLDER is additionally recommended
for use with the HM-90, since the HM-90’s internal battery re-
quires charging.
© Recommended connection
Use the
microphone’s
WIRELESS OPERATION
(
M@ HM-90 wiRELESS MICROPHONE |
The HM-90’s internal battery should be charged when the =
crophone is not being held. (
Charging period: 1.5 hrs. with timer (
(or 8 hrs. when battery is exhausted)
Operating period: 12 hrs (Operation : standby= 1 : 4)
© Charging method ’
Choose one of the following methods: (
> Connect the cable from the HM-90 to the EX-1759.
> Connect the BC-96 and EX-1759; then put the HM-90 int
the BC-96 (refer to the diagram at left). f
e Use the HM-90’s cable to connect the EX-1759 and BC-96.
Place the HM-90 into the BC-96 (with no connection to thi
EX-1759). (
e Use the CP-13L or OPC-288 to connect the BC-96 to a cigarett
lighter socket or a DC power supply, respectively. \
¢ Turning the wireless remote ON/OFF
When you use the HM-90 as a wired microphone, the wiré
less remote control circuit can be turned OFF.
Dip switch
The diagram shows that
the wireless remote con-
trol function is turned
ON.
AFC-OFF = PTT-M uw
PGR c-SQL oTmF DOFF
OHoOow