Icom IC-207H - Page 61

Bae a a creat nie ae a ae
4 EX-1759 installation
: EX-1759 INFRARED RECEIVER Can be installed for 2 differ-
ht purposes depending on the HM-90 charger. This is be-
puse the EX-1759 has both an infrared receiver and a
icrophone connector which contains microphone charging
pabilities.
When using the BC-96 with external DC input
jtach the EX-1759 to a suitable location for receiving in-
pled signals, e.g. sunvisor, etc.
hen using the connector for a microphone charger
tach the EX-1759 to a suitable location for receiving in-
hred signals and where it can be connected to a cable, e.g.
e console, etc.
j NOTE: DO NOT attach the EX-1759 where it will be sub-
, ject to direct sunlight as it cannot detect infrared signals
F under such conditions.
)
)
)
WIRELESS OPERATION 13
(When using BC-96
with external DC)
(When using the mic
connector for mic
charging.)
The installation clip can be oriented in 1 of 4 ways.
¢ Optional infrared sub receiver
An optional EX-1513 INFRARED SUB RECEIVER is available to
increase the remote control reliability and extend the control-
lable area. Connect the EX-1513 to the inside connector of
the EX-1759.
4% NOTE: The supplied microphone, HM-98, can be con-
Y nected and used with the EX-1759, however, the optional
Z wireless microphone cannot be used in such a case.
A
ENGLISH