4
ADVANCED FUNCTIONS
19
➀ Push [MR] to select memory mode.
➁ While pushing [(BAND)SCAN] rotate the tuning dial to
select the desired band.
➥ The following scan bands are selectable:
• “SEL ALL” for all channel scan.
• “SEL 144” for selected band scan of the 144 MHz band.
• “SEL 430” or “SEL 440” for selected band scan of the
430(440) MHz band, depending on version.
➥ After releasing [(BAND)SCAN], the selected scan starts.
➥ To activate the previously selected scan, dial rotation is
not necessary—just push [
(BAND)SCAN] for 1 sec.
➥ During scan, the following can be changed:
• Scan range using [(BAND)SCAN], with/without [DIAL].
• Scan direction using [DIAL].
➂ To stop the scan, push [(VFO)CLR].
D Memory (skip) scan
ALL CHANNEL SCAN: Repeatedly scans all programmed
memories, except for those set as skip channels.
BAND SELECT SCAN: Repeatedly scans all memories with
programmed frequencies in the 144 MHz band or 430(440)
MHz band, except for those set as skip channels.
ALL CHANNEL SCAN
BAND SELECT SCAN
(Example: 144 MHz band)
Not yet
programmed
SKIP
Mch 1
Mch 7
Mch 2 Mch 3 Mch 4
UHFUHF VHF
VHFVHFVHFVHF
VHF
VHF
UHF
Mch 5 Mch 6
Mch 8Mch 9
Mch 60 Mch 11 Mch 10
Not yet
programmed
SKIP
Mch 1
Mch 7
Mch 2 Mch 4Mch 3 Mch 5 Mch 6
Mch 8
Mch 60 Mch 11 Mch 10 Mch 9
IC-T7H-2.qxd 2007.07.19 4:10 PM Page 19
To Next Page
Loading...
