ICP DAS USA ET-7000 Series - Page 22


Cha
p
ter 1 Introduction
ET-7000 AIO User Manual, Apr. 2009, V1.04, EMH-011-104----------22
ET-7018Z I/O Specifications:
Analog Input
Input Channels 10 (Differential)
Input Type
+/-15 mV, +/-50 mV, +/-100 mV, +/-500 mV, +/-1 V, +/-2.5 V
+/-20 mA, 0~20 mA, 4~20 mA (Requires Optional External 125
Ohm Resistor)
Thermocouple (J, K, T, E, R, S, B, N, C, L, M, LDIN43710)
Resolution 16-bit
Sampling Rate 10 samples/ second total
Accuracy +/-0.1% or better
-3dB Bandwidth 15.7 Hz
Zero drift +/-0.5 μV/°C
Span drift +/-25 ppm/°C
Input Impedance > 300K Ohm
Common Mode Rejection 150 dB min.
Normal Mode Rejection 100 dB
Open Wire Detection Yes
Individual Channel Configurable Yes
Over Voltage Protection 240 Vrms
ESD Protection 4 kV Contact for each terminal, and 8 kV Air for random point
EFT Protection 4 kV for Power
Digital Output
Output Channels 6 (Sink)
Output Type Isolated Open-Collector
Max Load Current 700mA/ channel
Load Voltage 5 ~ 50 V
DC
DB-1820
Wire Strip Length 4~5 mm
Wire Range 16~24 AWG
Power Requirements
Power consumption 0.09 A/24 V
DC
(non-regulated)