Cha
ter 1 Introduction
ET-7000 AIO User Manual, Apr. 2009, V1.04, EMH-011-104----------24
Table 1-2 LED Indicators
Name LED Action Function
Run
Flashing Firmware is running
ON Ethernet link detected
OFF No Ethernet link detected
LINK/ACT
Flashing Green Ethernet packet received
OFF Speed 10 Mbps
10/100M
Orange Speed 100 Mbps
J1 Connector
Refer to Sec.1.3 Module Selection for more details regarding the pin assignments of the
J1 Connector for all types of ET-7000 series modules.
J2 Connector
Table 1-3 J2 Connector
Pin number Name Function
8 +VS 10 ~ 30 V
DC
power input
9 GND Ground connection
Note:
If the Run LED does not display the information as above, the following steps should be
taken:
z Switch the Power off
z Check that the Init/Normal switch is in the Normal position. (Refer to Back Panel
Description)
z Switch the Power on and double-check the LED indicators.
The definition of pin8 and pin9 applies
to all types of the ET-7000 modules.
The definition of the other pins is
dependent on the particular ET-7000
modules.
To Next Page
Loading...
