Page
3
Next
plug your RJ-45 network cable (shown be-
low) into the LANTAP port marked 10baseT Ether-
net. Plug the other end of this network cable into
the network port of you computer.
Pl
ease make sure you
have the correct IP
address and subnet
mask setup on the
network interface you
connected the LANTAP
Adapter to. You may
need to contact your
system administrator, or
aircraft vendor.
Note: For Cessna aircraft,
Cessna Customer Service
recommends an IP address of
192.1
68.200.196
or
192.168.200.197
To Next Page
Loading...