Manual IB-182aMU3
Package contents
1x IB-182aMU3, 1x USB 3.0 data cable, 1x screw set, 1x screw driver, 1x manual
Key features
• Compact and aluminium enclosure for mSATA SSD with up to 6 Gbit/s
• Interface to host computer: USB 3.0 Type-A, up to 5 Gbit/s
• Supports USB Attached SCSI Protocol (UASP)
• Downwards compatible to USB 2.0/1.2
• Compatible with Windows
®
and macOS
®
• Plug & Play and HotSwap
mSATA Installation
1. After opening, pull out the PCB
2. Fasten the mSATA by tightening the screws
3. Reinsert the mSATA + PCB on the intended track
4. Fasten the back cover by tightening the screws
Application
• The external SSD can be connected to or disconnected from the computer
via USB cable without shutting down the computer
• Please wait for the end of the read/write operations before disconnecting
the SSD to avoid data loss
• A new SSD must first be initialized, partitioned and formatted by the operati-
on system to be displayed by the system
• If the hard disc isn’t recognized instantly by the operating system please
check:
- if the driver software is installed (USB),
- if the SSD is initialized, partitioned and formatted
Manual IB-182aMU3
1.
2.
4.
3.
To Next Page
Loading...
Need help?
General