Icy Box IB-CR403-C3 User Manual

Manual IB-CR403-C3
Installation
1. Plug the USB Type-C
®
connector of the IB-CR403-C3 into an available USB3.0 Type-C
®
port
on your host computer.
Hint: As soon as the IB-CR403-C3 is plugged in, the blue status LED on the top lights up.
The IB-CR403-C3 is automatically recognised by the operating system and is immediately
ready to use.
2. Now insert the desired memory cards into the corresponding memory card slots of the
IB-CR403-C3.
• CFast: Before inserting the CFast memory card, make sure that the groove
(IB-CR403-C3) and the tongue (CFast memory card) are on the same side. Otherwise, the
CFast memory card cannot be inserted properly.
• SD: When inserting the SD memory card, make sure that the golden contacts are facing
upwards. The SD memory card clicks into place and is now properly installed.
• microSD: When inserting the microSD memory card, make sure that the golden contacts are
facing upwards. The SD memory card clicks into place and is now properly installed.
Usage
• The card reader can be connected to or disconnected from the computer during operation.
ATTENTION! Please await the end of write and read operations before disconnecting the
card reader from the computer to avoid data loss.
• A new memory card must first be initialized, partitioned and formatted by the operating system
before it can be displayed by the system.
• If the memory card is not immediately recognised by the system please check:
- whether the driver software is installed (USB)
- whether the memory card is initialized, partitioned and formatted

Icy Box IB-CR403-C3 Specifications

General

Brand	Icy Box
Model	IB-CR403-C3
Category	Card Reader
Language	English