15
• The boiler pipe connected to the horizontal chimney’s duct must not be longer than
2 m. Boiler pipe elbow should be used only until the chimney. (Site selection for
boiler should be determined by the closest point where the chimney.)
• To avoid turbulence around the chimney flue without any obstructions (high
buildings, trees, etc.) Must be 10 meter away at least.
• The pellet boiler should be mounted as close to the chimney as possible (chimney
connection should be short).
• Chimney cap should be used to prevent the flow into the chimney flue
repercussions of windy weather and rain. Concrete blocks is affected by
temperature changes, concrete flat roof which is in direct contact with the air must
be absolutely isolated.
Boilers must be connected to a chimney duct which can move vertically
smoke outside the building or its flue pipe to the highest point of the
building.
Chimney connections, if that would be considered illegal in the first
combustion fumes can cause the wall to infiltrate the processing of these
leaks may leave traces. Leaked smoke and / or flames can cause burns or
fire because it can be very hot.
To Next Page
Loading...
