36
Turbulator Cleaning
1. The covers (1, 5, 4) must be closed while the turbilator cleaning is being.
2. Open the top cover, and you will see the tubilator rods. Move the turbilator rods up
and down. Again the the moves until the turbilators are cleaned.
3. Then open the front cover and ashpit cover(1,5).
4. Remove the aspit, clean it.
5. You must do the screws off in figure A. Then clean the ashes pouring from the
tubilator.
6. Close the part (A) and tighten the screws.
7. Then replace the aspit.
Combustion pot cleaning
When cleaning the combustion pot, make sure it is completely cold. Vacuum cleaners
can be used if there is cold ash. You must check the combustion pot daily.
To Next Page
Loading...
