10
CZ
SK
EN
PL
HU
• Setting Networking
- Hold the Networking Setting Button in the
battery cover until the LED indicator starts flashing.
- Launch the App-[Start to add a main panel]-
[Quick Config Mode],following the guide line to
finish the networking process.
• Check Setting
• Finishing & Mounting
- Make sure your mobile phone has been connected to the Internet via cellular or WiFi.
- Try pressing ARM/DISARM button in App, to see if the status icon in App would be changed immediately.
- Try using remote control, pressing ARM/ DISARM button to see if the status icon in App would be changed immediately.
- Put the battery cover back.
- Place your main box on the desktop or using the bracket to mount it on the wall.
To Next Page
Loading...
