To Next Page
B
Brett MurphyAug 11, 2025
What to do if Ignition WAL-L Z150 COB RGBW Lighting Equipment has no response to the DMX controller?
- SShelly HowellAug 11, 2025
If your Ignition Lighting Equipment isn't responding to the DMX controller, first ensure that the DMX ports and cables are correctly connected. Also, verify the address settings and DMX polarity. Trying another DMX controller can help isolate the issue. Check to see if the DMX cables run near or alongside to high voltage cables that may cause damage or interference to DMX interface circuits.
General