Draco tera enterprise Configuration via OSD
105
Fig. 66 OSD Menu Configuration - EXT Units - Setting a USB CON EXT Unit
4. To configure an EXT Unit as a USB CPU Unit:
4.1. Select one of the EXT Units in the Ext Units list that are physically connected to a USB CPU Unit.
4.2. Set the USB-CPU (standalone) option to Y (C#1 in the Output Signals column).
4.3. Set additionally the Universal-CON option to N (C#1 in the Input Signals column).
4.4. Click Okay to confirm the setting.
Fig. 67 OSD Menu Configuration - EXT Units - Setting a USB CPU EXT Unit
5. The USB 2.0/USB 3.0 CPU/CON EXT Unit has to now be either assigned to an existing CPU/CON
Device or a new CPU/CON Device has to be created for the assignment:
• for a CPU Device see chapter 6.6.1, page 108,
• for a CON Device see chapter 6.7.3, page 119
After assigning EXT Units to CON/CPU Devices, the USB 2.0/USB 3.0 CON/CPU Ext Units are
configured and can be used.
6. If you use parallel operation within the matrix, set the Release Time in the System Settings > Switch
menu to 10 s or more (see chapter 6.3.4, page 80).
7. Restart all I/O boards on which USB 2.0/USB 3.0 EXT Units have been configured or alternatively
restart the matrix.
an EXT Unit from a USB CON to a USB CPU, a restart of the I/O board is necessary.
To Next Page
Loading...
