Configuration via OSD Draco tera enterprise
144
6.10.3 Activating a Predefined Configuration
Previously saved configurations are displayed in this menu. In Active, the currently loaded configuration is
displayed. To replace the current configuration by another configuration, in addition to the default
configuration (Default), one out of eight further, customized configurations (File #1 to File #8) can be
activated.
NOTICE
Activating a configuration will immediately disconnect and restart the matrix. The selected configuration is
loaded on restart and is shown in the menu as active configuration under Active. The previously active
configuration is overwritten.
The restart of the matrix may take several minutes, and the matrix is not available during the restart.
Fig. 96 OSD Menu Configuration - Open...
To activate a previously saved configuration, proceed as follows:
1. Select Configuration > Open in the main menu.
2. Select the desired configuration.
3. Click Okay to activate the selected configuration.
The selected configuration is immediately loaded and displayed in the menu as Active. The previously
active configuration is overwritten.
To Next Page
Loading...
