Ihse Draco tera enterprise 480 Series - Setting the Syslog Function; Fig. 109 Management Software Menu System Settings - Network - Syslog

Configuration via Management Software Draco tera enterprise
168
7.4.9 Setting the Syslog Function
NOTICE
For an activation of the Syslog function or changes of the IP address, a restart of the matrix or the
controller board is necessary. Restarting the matrix or the controller board may take several minutes, and
the matrix is not available during the restart.
The parameters for the Syslog function are set in this menu:
Fig. 109 Management software menu System Settings - Network - Syslog
The following parameters can be configured:
Field Entry/Status Description
Enable Syslog Activated Activate the Syslog server to query status requests.
Deactivated Function not active (default).
Syslog Server Byte Enter the IP address of the Syslog servers in the form
“192.168.1.1”.
Port Byte Enter the Syslog port (default: 514).
Log Level Debug Activate debug messages in Syslog (default: deactivated).
Note: The debug messages are exclusively for matrix
diagnostics. Only use this function for concrete debug cases as
it is not intended for normal operation.
Info Activate information messages in Syslog (default: deactivated).
Notice Activate notification messages in Syslog (default: activated).
Warning Activate warning messages in Syslog (default: activated).
Error Activate error messages in Syslog (default: activated).