Ihse Draco tera enterprise 480 Series - Reading Parameters; Changing Parameters; Fig. 130 Management Software Menu Extender & Devices - EXT Units - Displayed Parameters

Draco tera enterprise Configuration via Management Software
201
7.6.3.1 Reading Parameters
To read out and display parameters of an extender module, proceed as follows:
1. Click Extender & Devices > EXT Units in the task area.
2. Click Activate Edit Mode in the toolbar.
3. Select the EXT Unit of the extender module whose parameters are to be displayed.
4. Click the Parameter tab on the right side of the working area.
5. Click Read in the symbol bar of the tab.
A query to read the parameters appears.
6. Click Yes to confirm the reading.
The parameters of the extender module are read out and displayed on the right side of the working
area. At the same time, the connection will be disconnected for a few seconds.
Fig. 130 Management software menu Extender & Devices - EXT Units - Displayed parameters
7.6.3.2 Changing Parameters
To change parameters of an extender module, proceed as follows:
1. Click Extender & Devices > EXT Units in the task area.
2. Click Activate Edit Mode in the toolbar.
3. Select the EXT Units of the extender module whose parameters are to be displayed.
4. Click the Parameter tab on the right side of the working area.
5. Click Read in the symbol bar of the tab.
A query to read the parameters appears.
6. Click Yes to confirm the reading.