C42 SERIES Pilot Operating Handbook
POH Issue 4 Rev. 5 Page 45 of 91
Carefully check that both wing spars have properly locked into place.
Step 6 Attention! - Now immediately
1. insert mounting bolts into the front wing spar bracket
2. insert mounting bolts into the rear wing spar bracket
3. insert toggle bolt into the square cross-frame spar to secure the wing
support
4. All three bolts must be secured with the ring pins!
5. Lift the wing and check that the wing support is fixed by the
toggle bolt really reliable!
Repeat Step 1 to 6 for the other wing.
Remove any aileron locks used.
Step 7 attach right and left aileron push rods to the see-saw connection.
Carefully assure that the slide mechanism of the special ball-joint
connectors is in completely closed position.
Step 8 left and right flaps connection must be locked
Step 9 fasten wing center section fairing
Step 10 With Posi / Strobes installed, re-establish electrical connection
from fuselage to wing.
To Next Page
Loading...
Need help?
General
