C42 Owner’s Manual (Microlight) Page 7
Engine Limitations:
Max. Engine RPM. 5800 rpm (5 minutes max)
5500 rpm max continuous (80 HP)
5300 rpm max continuous (100 HP)
RPM Meter Markings: yellow 5500-5800 rpm (80 HP)
5300-5800 rpm (100HP)
red
5800 rpm
Propellers:
80hp: Warp Drive 2-blade 68” (1,72 m Ø)
Pitch 25º at R = 400 mm from hub edge (blade root point of entry)
Full throttle ground static RPM 5000 rpm (prop = 2203 rpm)
Warp Drive 3-blade 68’’ (1,72 m Ø)
Pitch 21º at R = 400mm from hub edge (blade root point of entry)
Full throttle ground static RPM 5000 rpm (prop = 2203 rpm)
Ecoprop 170R 110/3, 3 blade
170cm x 20º @ 75% radius.
Full throttle ground static RPM 5000 rpm (prop = 2203 rpm)
Neuform CR3 3 blade (1,75 m Ø)
Pitch 23º @ 310mm from hub edge
Full throttle ground static RPM 4700 rpm (prop = 2070 rpm)
Kiev Prop 263/1800 3 blade (1.70m Ø)
Pitch 24º @ 350mm radius
Full throttle ground static RPM 5000 rpm (prop = 2203 rpm)
100hp: Warp Drive 3-Blade 68” (1,72 m Ø)
Pitch 25º–26º at R = 400 mm from hub edge (blade root point of entry)
Full throttle ground static RPM 5000 rpm (prop = 2057 rpm)
Ecoprop 170R 130/3, 3 blade
170 cm, pitch 22º at 75% radius.
Full throttle static rpm, max. 5000 rpm (prop = 2057 rpm)
GSC Tech-III 3 blade
68” x 25º@400mm from hub edge.
Full throttle static rpm, max. 5000 rpm (prop = 2057 rpm)
Neuform CR3 3 blade (1,75 m Ø)
Pitch 27º @ 310mm from hub edge
Full throttle ground static RPM 4700 rpm (prop = 1934 rpm)
Neuform CR3-V-R2H 3 blade variable pitch prop (1,80 m Ø)
Pitch 24º-31º @ 310mm from hub edge
Full throttle ground static RPM 5400 rpm (prop = 2222 rpm)
Propeller pitch control lever position fully fine *
Kiev Prop 283/1800 3 blade (1.80m Ø)
Pitch 24º @ 485mm radius
Full throttle ground static RPM 4850 rpm (prop = 1996 rpm)
*
P
lease note the Neuform Variable pitch propeller has specific maintenance schedules deta
iled in
Neu
form Variable Pitch Propeller Operating Manual NOM/C42/001.
To Next Page
Loading...
