The StellarMate X Manual
113
/
260
You can go to an absolute angle position on your dome by tapping on the textbox next to
the Azimuth label and setting the angle value to go to. Now tap on the
GO
button to go to
that angle position. The dome will now try going to that position, the dome status badge will
show what type of rotation the dome is doing, and a compass preview will show a
representation of the dome angle. After the movement is complete, you will be able to see
the status badge change to "Tracking".
INDI Control Panel
INDI Control Panel provides an interface to interact with the drivers of the devices
connected to Stellarmate. It is a front-end for the INDI controls available on KStars.
To Next Page
Loading...