The StellarMate X Manual
146
/
260
Framing Assistant
To open the framing assistant, make sure to have selected an
FOV Profile
and press
Go
& Solve
.
StellarMate will command the mount to slew to the target location. This is indicated by a
magenta border around the target. Once Slew is complete, the alignment process begins
which is indicated by a yellow border. A red border indicated alignment error or alignment
is not within threshold. Please wait until the solver iterates to center the target exactly in the
center of the sensor. Once this is done, the border turns to Green. Now that the plate
solving is complete, you may proceed to use the Framing Assistant tool that helps you in
adjustment the orientation of the camera to match your desired orientation either manually
or automatically if a rotator device is detected.
Once the status turns to green (1), press the image (2) to open the
Framing Assistant
To Next Page
Loading...