The StellarMate X Manual
185
/
260
10. Wait a few seconds until a pop-up dialog shows up to confirm if the pairing and binding
process was successful or not.
Unbinding a Bluetooth Device
To stop a device from being auto-binded on startup, go to the Bluetooth Wizard by following
steps 1-4 and then click on
Unbind Previous Device.
A confirmation dialog will be shown to you.
Manual Pairing
Bluetooth dongles are supported. Before you can start communicating with your device
from StellarMate, you need to pair it. In order to pair the device, please log in to StellarMate
OS either via Direct HDMI connection or via
VNC Viewer
in the StellarMate App.
To Next Page
Loading...