Dirty filters and clogged spray arms
decrease the washing results.
Make a check regularly and, if necessary,
clean them.
Cleaning the filters
1
2
C
B
A
3
To remove filters (B)
and (C), turn the
handle counter-
clockwise and re-
move. Pull apart fil-
ter (B) and (C).
Wash the filters with
water.
4
A
Remove filter (A).
Wash the filter with
water.
5
D
A
Put filter (A) to its
initial position.
Make sure that it
assembles correctly
under the two
guides (D).
6
Assemble filters (B)
and (C). Put them
into position in filter
(A). Turn the handle
clockwise until it
locks.
An incorrect position of the filters can
cause bad washing results and dam-
age to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
Troubleshooting
The appliance does not start or it stops dur-
ing operation.
Before you contact the Service, refer to the
information that follows for a solution to the
problem.
With some problems, the display shows
an alarm code:
•
- The appliance does not fill with wa-
ter.
•
- The appliance does not drain the
water.
•
- The anti-flood device is on.
Warning! Deactivate the appliance
before you do the checks.
ENGLISH 14
To Next Page
Loading...
