9ENGLISH
IMPORTANT: clean the lters at least monthly
to remove any oil or grease residuals.
To clean the grease lter
The metal grease lter has an unlimited life
and must be washed once a month by hand
or dishwasher at low temperature and with a
short cycle. With cleaning in a dishwasher the
grease lter may become dull; this does not
effect its ltering capacity.
Grease lter maintenance:
1. Unplug the appliance or disconnect the
power supply.
2. Remove the grease lters: pull the spring
release handle, then remove the lter
downwards.
3. After cleaning the grease lter, remount
in reverse order ensuring the entire
extraction surface is covered.
Charcoal lter maintenance (if the hood is
installed in recirculation installation)
1. Pull out the plug or disconnect the power
supply.
2. Remove the grease lter
3. If the carbon lters are already tted
(two lters that cover the protective
grilles for the motor impeller) and have
to be replaced, turn the central handle
anti-clockwise to unlock them.
4. Open the two lter shells
5. Pull out the two circular mats
6. Proceed in reverse order to t the new
lters.
7. Ret the grease lters.
Unlike traditional charcoal lters, this charcoal
lter shall be washed and reactivated.
Care and cleaning long life Charcoal lter
• The anti-odour lter shall be washed and
regenerated every 3-4 months (or more
frequently if the hood is subject to intensive
use), up to a Max. of 8 regeneration cycles
(in case of particularly intensive use it is
recommended that you do not exceed 5
cycles).
Regeneration procedure:
• Wash in the dishwasher at a MAX tem-
perature of 70° or hand wash in hot water
without using abrasive sponges (do not
use detergents!)
• Dry in the oven at a MAX temperature of
70° for 2 hours or dry at room tempera-
ture, standing the lter in a vertical posi-
tion to facilitate drainage.
2x
Lamp maintenance
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the Authorized
Service Centre.