Select UL Listed/CSA Approved twist-on wire connectors rated to
connect your power supply cord to 16-gauge dishwasher wiring.
Electrical Shock Hazard
ElectrJcMiy ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
-'-" Connect ground wire
__ __ _:_
o
%LtAd /'_II--G round /
1[__,_]_ - wire L' _ro._no-
_,kI kkk_"J/_F---_ t _.Z--W''e
ashe
)
Remove the green grounding screw and place through the ring
terminal of the green ground wire. Reattach and tighten the green
screw.
J _:
Power CordmConnect
remaining wires
NOTE: Do not pre-twist stranded wire. Twist on wire connector.
Gently tug on wires to be sure both are secured.
Connect wires black to black and white to white, using UL Listed/
CSA Approved twist-on wire connectors.
If needed, see website for animated representation of this step.
Visit www.whirlpool.com/electrical under FAQ tab.
Tighten strain relief screws to secure cord.
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside box. Close cover ensuring
wires are not pinched. Use 1/4"nut driver or Torx T20 screwdriver
and previously removed screw to secure cover.
NOTE: Do not plug into outlet until instructed to do so.
14
To Next Page
Loading...
