INSTALLATIONREQUIREMENTS
Gather the recommended tools and parts before starting
installation. Read and follow the instructions 3rovided with any
tools listed here.
All Installations
Tools needed:
Pliers
Phillips
screwdriver
5 _ 1 M_
_6 and ¼
nut drivers or _._
hex sockets
Measuring tape _
or ruler
10" adjustable wrench /_
the! opens to _
11/8' (2.9 cm)
Flat-blade
screwdriver
Uti Ety knife
Approved twist-on _ _
wire connectors*
Small level S
%" open-end
wrench
Torx ®t1"20 screwdriver
*Must be the proper size to connect your household winng
to 16-gauge wiring in dishwasher.
Other useful items you may need:
pan "_-_._ Jtowel_J
Parts supplied:
Drain hOse Drain #10 X ½" 2 _ under'
Clamps (2)hose Phillips-head Counter
(1large and screwS (2) mounting
brackets
sm
Make sure all these parts are included in the literature package.
1-®TORX is a registered trademark of Saturn Fasteners, Inc.
Parts needed:
m
Y8Compr x _ hose fitting
For part OrMt, see local
retailer or Call Whirlpoo!
Parts: 1'800-442=9991, Part
Number W10273460
Other parts you may also need:
I ,A-2 I Maskingor MoistUre _1
I (3.81_5 cm) I duct tape barder tape _1
_ Screw-tYPe I (Part Number ri_
NOTE: Parts available for purchase in plumbing supply stores.
Check local codes. Check existing electrical supply. See
"Electrical Requirements" section. It is recommended that
electrical connections be made by a licensed electrical installer.
In addition, for first-time installations
Toolsneeded:
Parts needed:
i
Copper tubing (%, See "Electrical Requirements" section.
Oe.Dsuggested) or I .. : _ ,. .. .
Xible braided For uirect Wire: r-or r'ower _upply
-,*_r x._,-,-i,, li"_ use UL Listed/ cord: use UL
CSA Approved Listed/CSA
strain ielief ApproVed power
(_t_\k_._ _),_.) tofit% (2.2cm) supplyc0rd kit
I h01e I marked f°[ use with
_" ' dishwasher
To Next Page
Loading...
