EasyManua.ls Logo

IKEA IUD8500BX0 - INSTALLATION REQUIREMENTS; Tools and Parts

IKEA IUD8500BX0
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTALLATIONREQUIREMENTS
Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with any
tools listed here.
All Installations
Toolsneeded:
p Flat-blade
ers I screwdriver
5/_6"and V4" _ UL Listed/CSA
nutdr versor Approvedtw st-on
hex sockets _ wire connectors*
10" adjustab e wrench %" n
. h _ ope -end
that opens to ..,SJJ_ wr^n^h .__J"
1 i _ £'
1V8' (2.9 cm) _1
If installing custom front panels,
Torx ®_T15 ® screwdr vet
*Must be the proper size to connect your household wiring to
16-gauge wiring in dishwasher.
Other useful items you may need:
Ehl!ght_ _ Bath __i
towel -_i" !
Parts supplied:
Parts needed:
%,i C0mpr X ¾, hose fitting
For part or kit, see local
retailer or call Whirlpool
PartS:1-800'442;9991' Part
Number W10273460
I<_TORX and T15 are registered trademarks of Saturn Fasteners, Inc.
Supplied in Kit (Panel Ready models only):
4 Plastic studs (attached to each other by runners)
4 Short screws (10-16 hex head screw)
4 Long screws (8-18 Torx®head screws)
1 Template (located inside Use and Care Guide bag assembly)
1 Instruction sheet (located inside Use and Care Guide bag
assembly)
NOTE: The screws supplied are used for only 3/4"thick wooden
panel. If the wooden panel is less than 3/4"thick, customer must
purchase screws locally.
Other parts you may also need:
I 1' " 2" Masking or Moisture
(3.81_5 cm)duct tape barrier tape ._/_
I Sc[ew _type I (Part Number/_/
I 4396277)
NOTES:
Moisture barrier tape is recommended when installing a
dishwasher under a wood countertop.
Parts available for purchase in plumbing supply stores. Check
local codes. Check existing electrical supply. See "Electrical
Requirements" section. It is recommended that electrical
connections be made by a licensed electrical installer.
In addition, for first-time installations
Toolsneeded:
I TL
I and 11/2'' hole _]/
Parts needed:
Copper tubing (%"
O.D, suggested) or
flexible braided
See ,,Electrical Requirements" section:
For Direct wire: For P0wer Supply
use UL Listed/ cord:use UL
CSA Approved ListediCSA
strain ,r,elief ApproVed power
tofit_ (2_2cm) SUpplycord kit
hole marked for use with
dishwasher

Related product manuals