heat up, and the safety device to switch
off, otherwise the gas supply would be
interrupted.
3. After the flame is regular, adjust it as
preferred.
If after a few attempts the burner
does not ignite, check that the
crown and its cap are in correct
positions.
1
Burner cap
2
Burner crown
3
Ignition candle
4
Injector
5
Thermocouple
Warning! Do not keep the
control knob pressed for more
than 15 seconds. If the burner
does not light after 15 seconds,
release the control knob, turn it
into off position and wait for at
least 1 minute before trying to
light the burner again.
In the absence of electricity you
can ignite the burner without
electrical device; in this case
approach the burner with a
flame, push the relevant knob
down and turn it counter-
clockwise to maximum gas
release position.
Warning! Maintain extreme
caution when using open fire in
kitchen environment.
Manufacturer decline any
responsibility in case misuse of
the flame.
If the burner accidentally goes
out, turn the control knob to the
off position and wait for at least
1 minute before trying to light it
again.
When switching on the mains,
after installation or a power cut,
it is quite normal for the spark
generator to be activated
automatically.
Turning the burner off
To put the flame out, turn the relevant
control knob to the symbol .
Warning! Always turn the flame
down or switch it off before
removing the pans from the
burner.
Hints and tips
Warning! Refer to Safety
chapters.
Diameters of cookware
Use pots and pans with bottom fitting the
size of burner used.
ENGLISH 10
To Next Page
Loading...
